911 Carrera S Cabriolet (997) F6-3.8L (2007)
Shop light
Socket-wrench insert a/f 10/13 mm
Side cutters, needle-nose pliers
Flat screwdriver (medium)
Phillips screwdriver (medium)
Battery charger
Torx wrench T20/T25/T30
Repair kit for wire harness NR.155-1
PIWIS Tester P 9718
Torque wrench, signal-transmitting with changeover ratchet NR.90
Disassembly tool P 9570/1
Hot-air gun
Work procedure:
1
Preparatory work.
1.1 Remove battery. --> Workshop Manual '270619 Removing and installing battery'
1.2 Remove luggage compartment cover. --> Workshop Manual '703019 Removing and installing luggage compartment cover'
1.3 Remove covers at the left and right close to the cowl panel. --> Workshop Manual '852219 Removing and installing cover - section on
"Removing"'.
1.4 Remove cowl panel cover. --> Workshop Manual '508719 Removing and installing cowl panel cover'
1.5 Only for vehicles with a telephone:
Remove radio antenna (telephone) from cowl panel cover. --> Workshop Manual '914719 Removing and installing radio antenna'
ATTENTION:
Risk of damage to components.
-
Risk of damage to dryer (fluid tank) due to drilling work on the grommet.
--> Protect dryer (fluid tank) using a wooden support.
--> Use a bit stop while drilling.
2. Install GPS antenna, --> Workshop Manual '911319 removing and installing GPS antenna'.
2.1 Insert speed nut (999.507.441.02) in cowl panel cover.
2.2 Position GPS antenna and secure with a tapping screw (999.073.210.00)
3. Only for vehicles with a telephone:
Fit radio antenna (telephone) on cowl panel cover. --> Workshop Manual '914719 Removing and installing radio antenna - section on "Installing"'.
4. Prepare trim panel for luggage compartment pan.
4.1 Loosen trim panel for luggage compartment pan.
4.2 Only for 911 Carrera 4:
Transfer dimensions for the position of the mounting for the navigation unit retaining frame to the trim panel for the luggage compartment
pan.
Dimensions:
V = 135 mm
X = 145 mm
Y = 190 mm
Z = 205 mm
4.3 Cut out section in luggage compartment pan for navigation unit retaining frame in accordance with dimensions.
4.4 Check cut-out in the trim panel for the luggage compartment pan for mounting the navigation unit retaining frame and rework it if necessary.
5. Route GPS antenna line.