911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
Seal the gap between the rear body center panel (arrows, figure 15) and side members from the outside using silicone free body sealer. Depending on
the body color, a light or dark sealer should be used which can be painted.
-
Angle the tip of the sealer cartridge.
Start at the bottom of the seam and apply the sealer.
Remove any excessive sealer.
-
After approximately 30 minutes drying time, paint over the sealer in the vehicle exterior color.
General Information:
After completion of all sealing repairs, water test the vehicle. Reinstall all removed components. Road test the vehicle.
Literature:
Refer to the 911 Carrera Workshop Manual (993) Volume 5, Supplement "Targa" and the Introduction Brochure.
Parts Information: