911 Carrera Targa F6-3600cc 3.6L SOHC (1996)
-
Remove metal burrs from the cut off area of the bracket (Figure 8, arrow 2A) and cover the exposed metal with anti-corrosion paint.
-
Check the o-rings under the wind deflector bearing block (2 each) and if necessary replace with part number, 993 562 537 00.
-
Install new torx bolts (Figure 9, arrow 2), part number, 993 562 567 00 and torque to 5.5 Nm (4 ft/lb). (bolt with washer, same as on figure 9, arrow
3).
Note:
As of June 17, '96 the modification to the corner plate bracket was performed in production.
As of January 22, '97 the bolts on the securing points (Figure 9, arrows 3) were changed from M5 x 9.5 to M6 x 10 (part number, 993 562 741 00) bolts.
The longer bolts cannot be installed in earlier vehicles.
Torque values:
Securing points
"2" and "3" with bolts M5 x 9.5 = 5.5 Nm (4 ft/lb).
Securing points
"3" with bolts M6 x 10 = 9.5 + 5 Nm (7 ft/lb).
3.2
Replace the left and right side bolts for the roof module on the windshield frame.
Note:
As of June 12, '96, new collar bolts are installed (Figure 10 arrows) on the windshield frame/roof module, part number, 900 378 163 09.
-
Replace the securing bolts (Figure 10, arrows). On earlier vehicles remove the existing allen head bolts (Figure 10, arrows) one at a time and replace
with the new collar bolt, part number, 900 378 163 09 (M6 x 16 micro encapsulated) without washers, and torque to specifications.
