911 GT2 (996) F6-3.6L Turbo (2003)
Fuel Cooler: Service and Repair
Removing and Installing Fuel Cooler
Removing Fuel Cooler
NOTE:
-
It is necessary to remove the refrigerant by suction before removing the fuel cooler.
-
The safety regulations must be observed during all work on the refrigerant system. (See: Safety regulations when handling refrigerant R134a)
1. Suck refrigerant out of the charging valves in the luggage compartment.
2. Open the engine compartment lid and disconnect the refrigerant lines from the fuel cooler. Immediately seal the openings with suitable plugs.
3. Disconnect the negative terminal of the battery.
WARNING:
Danger of fire and injury. Observe general safety regulations on the fuel system. Wear protective gloves that are fuel-resistant. Ensure that
there is adequate ventilation.
CAUTION:
Always counter at the fuel lines when undoing them.
4. Undoing fuel lines. Counter union nut with a/f 17 and with a/f 14.
5. Collect residual fuel. Undo holding clamp and remove fuel cooler.