911 GT2 (996) F6-3.6L Turbo (2003)
2. Position the throttle body on the intake distributor and position and tighten the four M6 screws -arrows-.
Tightening torque of M6 screws = 10 Nm (7.5 ftlb.)
3. Position the Y-shaped pressure pipe with the rubber air cowl on the throttle body, connect the vacuum hose -3- and fasten the spring band clamp.
Connect the connector of the pressure sensor -4- and position and tighten the M6 screws -1 and 2-.
Tightening torque of M6 screws = 10 Nm (7.5 ftlb.)
4. Install the holder over the air-conditioning compressor. Position and tighten the M6 screw in the holder for this purpose.
Tightening torque of M6 screw = 10 Nm (7.5 ftlb.)
5. Connect hose to the Y-shaped pipe and fasten with the spring band clamp -arrow-.
6. Install the pressure hoses between the charge air coolers and the Y-shaped pressure pipe; the pressure hoses must engage audibly.
7. Install air cleaner housing.