porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Restraint System - Air Bag Service Information|Page 2856 > < Air Bag(s) Arming and Disarming|Service and Repair
Page 1
background image

Air Bag: Technical Service Bulletins
Restraint System - Air Bag Service Information

911 Turbo (996)

2/03

6959

Binder - 6, Body Equipment

Date: 6-27-03

New Passenger's Airbag

Vehicle Type:
911 Turbo (996) / 911 GT2 (996)

Model Year:
As of '01 (1)

Concerns:
New Passenger's airbag (in the dashboard) available as replacement spare part.

Information:
A new passengers airbag has been installed as from the introduction date below. Simultaneously, the plug connection or the 2-pin plug on the airbag has
been changed.

Identifying features:

The new airbag is identifiable only by means of the new part No. The 2-pin plug is colored green (was yellow) and has a different shape.

Introduction:

June 5, 2003 as of the VINs:

99 63S 68 7098 - 911 Turbo (996) USA
99 23S 69 6185 - 911 GT2 (996) USA

The new airbag can be retroactively installed during repair work. For installation in vehicles prior to the above-mentioned introduction date, service
wiring harness, Part Number, 996 612 030 00 must be used additionally.

Parts Information:

Tools:
Repair kit for wiring harnesses (Messrs. Cartool)
Press-out tools Nos. 89072 and 90207 (from 12-piece Porsche press-out tool set)
Side cutters
Adhesive tape

Work Procedure:

Install new passengers airbag in vehicles prior to the above-mentioned introduction date. The service wiring harness with the green 2-pin plug must be
additionally installed in this case.

1.

Remove the passenger's airbag from the dashboard, see 911 Turbo Technical Manual, Group 6, Chapters 69-1 - Safety regulations for airbag
vehicles and 69-6 - Removing and installing the passenger's airbag unit.

2.

As far as possible, cut off and tie the existing wiring harness to the passenger's airbag (with yellow 2-pin plug) on the main wiring harness.

3.

Starting from the airbag, route the service wiring harness downward to the airbag control unit (on the center console). To facilitate threading of the
wiring harness, tape together the two wires in the area of the receptacles.

Restraint System - Air Bag Service Information|Page 2856 > < Air Bag(s) Arming and Disarming|Service and Repair