911 GT2 (996) F6-36L Turbo (2003) Oil Temperature Sensor/Switch - Specifications (Page 411)
Oil Temperature Sensor/Switch: Service and Repair
Removing and Installing Oil Temperature Sensor
Removal
1. Undo fastening screw M6 x 34 on the air cleaner housing (A/f 13).
2. Undo hose clamp between the air cleaner housing and intake manifold.
3. Pull off electrical wire connector of the hot film mass air flow meter:
-
To do this, push the plug downwards and press on the grooved surface at the sides.
-
Then pull the connector up and off.
-
Open the omega clip on the left side of the air cleaner housing and take out the electrical wire of the hot film mass air flow meter.
-
Re-close the omega clip for the removal (risk of breakage)
4. Tilt the complete air cleaner housing 90° upwards and remove rearwards.
5. Pull off the connecting hoses between the charge air coolers and the pressure pipe. To do this, unclip the locking clips with a screwdriver. Then
return the locking clips to installation position. Additionally undo a fastening screw on the right-hand pressure pipe side.