911 GT2 (996) F6-3.6L Turbo (2003)
3. Unscrew the fastening screw between the halfshaft flange and the transmission.
4. Unscrew the halfshaft flange out of the transmission past the drive shaft.
5. Lever out sealing ring using a suitable tool.
Installing Sealing Ring For Halfshaft Flange
1. Fill the space between the dust and sealing lips with grease (e.g. Liqui-Moly) and drive in the sealing ring up to the mounting face with special tool
pressure piece No. 9252.
2. Push in the halfshaft flange and tighten the fastening screw. If necessary, hold the halfshaft flange with 2 screws.
Tightening torque: 44 Nm (32 ftlbs.).
3. Fitting the halfshaft flange on drive shaft
Tightening torque: 81 Nm (61 ftlb.).
4. Clip in the B-plus cable in the holder (only the right side).
Tightening Torques