911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-877002.png)
The wire harness is secured onto the unpainted bodyshell with a strip of adhesive tape. The strip of adhesive tape is located on the outside of
the protective sleeve for the wire harness.
3.
Open the Velcro fastener for the protective sleeve (Figure 1, arrow) of the wire harness.
4.
Remove locating tape on the end of the antenna lead (Figure 2, Item A) and guide the antenna lead (Figure 2, Item B) over a length of
approximately 300 mm out of the wire harness.
5.
Shorten the antenna lead by 100 mm measured from the upper end (Figure 3).
Caution!
Failure of remote control if the antenna length is incorrect!
>
Different antenna lengths are necessary, depending on the frequency of the remote control.
>
The length of the antenna is determined by removing the shielding (outer plastic sleeve and underlying metal weave) from the antenna lead.
>
The length of the antenna is:
-
for a frequency of 315 MHz: 130 (USA/Canada/Mexico/Australia/Japan/Hong Kong)
-
for a frequency of 433 MHz: 100 mm (all other countries).
6.
Measured from the upper end of the antenna lead, carefully cut through the shielding of the antenna lead with side cutters a length of:
