911 Targa (996) F6-3.6L (2004)
You can use this menu item to code the traffic broadcast loudspeaker boost in the PCM2.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 MMI function selection and confirm with the >> key.
-
Select Traffic broadcast loudspeaker boost in the PCM2 MMI function selection and confirm with the >> key.
-
Code the selection required with the F8 key.
Menu item
-
Time
Function
Using this menu item, you can code the current time.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 MMI function selection and confirm with the >> key.
-
Select Time in the PCM2 MMI coding function selection and confirm with the >> key.
-
Use the arrow keys to select the required Time and code with the F8 key.
Menu item
-
Time zone
Function
Using this menu item, you can code the required time zone.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Coding in the PCM2 MMI function selection and confirm with the >> key.
-
Select Time zone in the PCM2 MMI coding function selection and confirm with the >> key.
-
Select the required Time zone and code with the F8 key.
Vehicle Hand-Over
Vehicle Hand-Over
NOTE: The CDR23 is converted into production mode (low-current mode) in production. As known from other systems (alarm system, instrument
cluster, amplifier, roll-over bar), the CDR23 must be activated with the Porsche System Tester II 9588.
1. Connect and start the Porsche System Tester II 9588 and switch on the ignition.
2. Select Special functions in the Vehicle type menu and confirm with the >> key.
3. Select Vehicle hand-over in the Control modules menu and confirm with the >> key.
4. Follow the instructions of the Porsche System Tester II 9588
Display * in the menu Control modules and menu PCM2/ CDR23 MOST component check
Different required and actual installed components lists When the automatic control module search is complete, the following display * appears in front
of the control module description PCM2 in the Control modules menu, as well as in the PCM2 MMI function selection in front of the entry MOST
required installed components list if the Porsche System Tester II 9588 establishes a difference between the required and actual installed components list
and there is no fault code in one of the fault memories of the MOST control modules.
If there is a fault code present in one of the MOST control modules, the display * is only shown in the PCM2 MMI function selection in front of the line
MOST required installed components list.
If there is a display in the menu Control module, an existing fault code has priority and a # is set.
CDR23 Replacement
The CDR23 is supplied as a spare part in production mode ON. Each time the vehicle is started, the stored CDR23 code is compared with the code in the
instrument cluster. If they match the device is operational.