porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 4669 > < Initial Inspection and Diagnostic Overview|Page 4667
Page 93
background image

-

Select '911 (996)' in the Vehicle type menu and confirm with the >> key.

-

Select 'PCM' in the Control units menu and confirm with the >> key.

-

Select 'CDR23' in the 911 (996) PCM2 function selection and confirm with the >> key.

-

Select 'Coding' in the 911 (996) CDR23 function selection and confirm with the >> key.

-

Select 'Tuner parameters' in the 911 (996) CDR23 coding function selection and confirm with the >> key.

-

Select the required 'tuner parameters' in the CDR23 Modify coding function selection and confirm with the F8 key.

-

Traffic broadcast
loudspeaker boost

You can code the traffic broadcast loudspeaker boost using this menu item.
-

Connect and start the Porsche System Tester II No. 9588 and switch on the ignition.

-

Select '911 (996)' in the Vehicle type menu and confirm with the >> key.

-

Select 'PCM2' in the Control units menu and confirm with the >> key

-

Select 'CDR23' in the 911 (996) PCM2 function selection and confirm with the >> key.

-

Select 'Coding' in the 911 (996) CDR23 function selection and confirm with the >> key.

-

Select 'Traffic broadcast loudspeaker boost' in the 911 (996) CDR23 coding function selection and confirm with the 
>> key.

-

Use the arrow keys to select the required 'traffic broadcast loudspeaker boost' in the CDR23 Modify coding function
selection and confirm with the F8 key.

Data Transfer Fault

If faults are detected when the data is decoded, this is known as a data transfer fault. The faults can arise when the data is encoded, when the data is
transferred through an input level that is optically too low or when the data is decoded. A fault entry is not recorded.

Diagnosis Distribution Line

The diagnosis distribution line is an electrical lead, which, as a stub cable, connects the individual MOST control modules in the system with one
another. The existing MOST control modules are checked at regular intervals during communication with the control modules via the electrical/optical
MOST.

Function Of The Components

Initial Inspection and Diagnostic Overview|Page 4669 > < Initial Inspection and Diagnostic Overview|Page 4667