911 Targa (996) F6-3.6L (2004)
-
Set default values
-
Ring break diagnosis
-
Ring break line diagnosis
NOTE: The activated drive link is automatically switched off after approximately 20 seconds.
Menu item
-
Display colour black
Function
Using this menu item, the function Display colour black can be checked.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Drive links in the PCM2 MMI function selection and confirm with the >> key.
-
Select Display colour black in the PCM2 MMI drive link function selection and confirm with the F8 key.
-
The display must show the correct colour.
Proceed in the same way with the following tests.
-
Display colour coloured bars
-
Display colour blue
-
Display colour red
-
Display colour green
-
Display colour white
Menu item
-
Set default values
Function
Using this menu item, you can read out the set default values from the PCM2 MMI.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Set default values in the 911 (996) PCM2 MMI function selection and confirm with the >> key.
-
Read out values from the display field.
Menu item
-
Ring break diagnosis
Function
Under this menu item, it is possible to check the electrical and optical MOST during troubleshooting.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control modules menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Ring break diagnosis in the 911 (996) PCM2 MMI function selection and confirm with the >> key.
-
Read out values from the display field.
Menu item
-
Ring break line diagnosis
Function
Using this menu item, you can check the ring break diagnosis line.
-
Connect and start the Porsche System Tester II 9588 and switch on the ignition.
-
Select 911 (996) in the Vehicle type menu and confirm with the >> key.
-
Select PCM in the Control module menu and confirm with the >> key.
-
Select PCM2 MMI in the 911 (996) PCM2 function selection and confirm with the >> key.
-
Select Ring break line diagnosis in the 911 (996) PCM2 MMI function selection and confirm with the >> key.
-
Read out values from the display field.
CDR23