911 Targa (996) F6-3.6L (2004)
Tow Sensor: Service and Repair
Converting Installation Position For Tilt Sensor, Additional Alarm System M536
NOTE:
-
As from model year 2002, the tilt sensor will be installed under the left front seat next to the alarm control module.
-
In vehicles up to model year 2001 inclusive, the tilt sensor is located in the radiator tank to the right of the battery.
-
If a new tilt sensor must be replaced in vehicles produced before model year 2002, the conversion procedure described below must be carried out.
-
In connection with the the parking assistant control module, a new bracket (from model year 2002), a new tilt sensor, a bracket for the tilt sensor
and a wiring harness will be required for the conversion.
-
Disconnect battery.
-
Use the wiring diagram for the central locking alarm system, sheet 8 / 8A.
1. Remove the battery cover and the right cowl panel cover.
2. Pull off the plug on the tilt sensor.
3. Unscrew the fastening nut -arrow- .
4. Remove the tilt sensor and tie the electrical lead with insulating tape.
5. Fit the battery cover and the right cowl panel cover.
6. Remove the left front seat.