911 Targa (996) F6-3.6L (2004)
INFORMATION:
-
Bowden cable of variant A is to be installed in vehicles up to Veh. Ident. No.
-
99 ZXS 60 0957 RoW
-
99 ZXS 60 0512 RoW
-
99 9XS 60 3889 USA
-
99 1XS 60 2307 USA
Up to Veh. Ident. No. inner door release of variant A
INFORMATION:
-
Inner door release of variant A is to be installed in vehicles up to Veh. Ident. No.
-
99 ZXS 60 0957 RoW
-
99 ZXS 60 0512 RoW
-
99 9XS 60 3889 USA
-
99 1XS 60 2307 USA
Removal and installation of bowden cable variant A
Cut open tie-wrap -1- when removing the door trim panel. Unclip bowden cable from the door handle.
1. Engage bowden cable in the door handle. The bowden cable must always be set free of play. When installing the bowden cable -3- in the door
handle -2-, secure the connection -1- using a tie-wrap. Refer to Removing and installing inner door release (bowden cable) for door lock.
Installation notes on door film
Installation note on door film for vehicles without side airbag
The spare door film comes with 4 holes for fastening the side airbag.
For vehicles without airbag, the holes in the door film -2- must be covered with commercially available adhesive tape -1-.
Notes on the installation of partly detached door film
Door films which have become completely detached or are torn must always be replaced.
In the case of door films which have become partly detached at the top and side, the detached films must be reattached using a butyl sealing cord.