911 Targa (996) F6-3.6L (2004)
8. Fastening seals and retaining strip at the sides of the roof frame
The seal on the roof frame at the sides consists of two parts.
a. Position the upper seal -6- onto the retaining strip -7- in -direction of arrow A- and screw on to roof frame with the Torx screws T15 -8-.
Tightening torque: 2.8 Nm (2.0 ftlb.)
b. Press the lower seal -5- into the profile of the retaining strip -7-.
9. Fastening tension cable of the convertible-top covering
Position the tension cable eyelet -3- on the main bow and fasten with the T25 -4- Torx screw.
Tightening torque: 7 Nm (5 ftlb.)
10. Fastening convertible-top covering on the tension bow
NOTE: Cut-outs have been integrated to the right and left of the additional seal.
a. Integrate the additional seal parallel to the tension strap -C- into the cut-outs on the right and left using a knife.
b. Press tightening strip centre (notch marking) -inset A- into the lower groove of the tension bow -inset B- (centre of the tension bow is
identified by a hole) -inset A-.
c. The reference overlap seams of the convertible-top covering must be positioned and centered in the additional seal -arrow C cut-outs on the
left and right.
d. Secure the convertible-top covering by tapping in the seal -inset D-.
11. Fitting tension bow seal
a. Press tension bow seal into the lower groove of the tension bow and fasten at both ends with the T25 Torx screws -2-.
Tightening torque: 5 Nm (3.5 ftlb.).