911 Targa (996) F6-3.6L (2004)
8.1. Position lid hinge -4- on roof module frame and tighten with fastening nuts -5-.
9. Installing seal for cover of rear window
9.1. Push seal -6- all the way round the flange of the roof module.
10. Installing seal for the centre joint
10.1. Insert seal for the centre joint -7- into the module frame in -direction of arrow-. The seal must connect on the left and right so that it is flush.
11. Sticking on Nito tape
11.1. Stick the Nito tape all the way round the roof module starting from the centring pegs at the front.
12. Installing roof module
12.1. Refer to Removing and installing roof module - Targa.
13. Installing cover for sliding roof
13.1. Refer to Removing and installing cover for sliding roof - Targa.
13.2. Refer to Removing and installing cover for sliding roof - Targa.
14. Installing electric motor for sun blind
14.1. Refer to Removing and installing electric motor for sliding roof sun blind - Targa.
15. Installing rear window cover
15.1. Refer to Removing and installing rear window cover - Targa.
16. Setting the microswitch of the sliding roof > closed <.
16.1. Refer to Removing and installing electric motor for sliding roof - Targa.
17. Setting closing aid
17.1. Refer to Removing and installing closing aid - Targa.
17.2. Refer to Removing and installing closing aid - Targa.
18. Functional inspection
18.1. Connect the Porsche System Tester to the diagnostic socket. Switch ignition on.
18.2. Select menu item Targa roof, select menu item actuators, actuate open/close function or actuate rear cover function.
18.3. Read out fault memory. If necessary, proceed according to "0-60 Targa roof diagnosis" in the case of an error entry.
19. Installing linings