911 Targa (996) F6-3.6L (2004)
2. Install and fasten upper microswitch -1- with bracket
Turn threaded spindle until the fastening screws -2- can be screwed down with an angle screwdriver (Torx T10).
3. Fasten the line routing
Fasten the line under the upper microswitch with a tie wrap. Position line in the retaining clip.
4. Install lower microswitch
Install lower microswitch and fasten the fastening points (plastic) with the retaining clips or carefully heat them with a soldering iron until the
material starts to flow. The microswitch must be seated firmly in the fastening points after the material cools.
5. Fasten the line routing
Fasten the cable under the lower microswitch with a tie wrap.
6. Install rear side section flap.
Tools and materials