911 Targa (996) F6-3.6L (2004)
Brake Master Cylinder: Service and Repair
Installation
Installation
1. Install in reverse order.
2. Bleed the brakes Serv. No. 47 01 07 (vehicle with ABS and ABS/TC) and Serv. No. 41 01 07 - (vehicle with PSM).
Note!
^
First bleed brakes as usual!
^
Only after this (after the conventional bleeding) should the return pump actuation be performed (continue bleeding) with the Porsche System
Tester 2 in vehicles with TC (Traction Control) or the booster pump control in the case of vehicles with PSM! If this is not observed, damage
can occur to the return pump/booster pump!
^
To bleed at rear on right with running return pump (TC) or at front right with running booster pump (PSM), the bleeding device remains
connected (switched on)! Bleeding pressure approximately 2.0 bar!
3. Bleed the clutch in manual transmission vehicles.
4. Carry out a function check of the brakes.