911 Targa (996) F6-3.6L (2004)
Hydraulic Control Assembly - Antilock Brakes: Procedures
Removing And Installing Hydraulic Unit
Removal
NOTE: For the removal and installation of the hydraulic unit -D- the brake master cylinder -B- and the brake booster -C- remain mounted (installed).
1. Switch off ignition. Remove cover -A- from the hydraulic unit/brake unit.
2. Hold down brake pedal with pedal holder, so that the brake fluid does not run out of the expansion tank completely.
3. To remove the hydraulic unit -D-, carry out the following removal procedure: