911 Targa (996) F6-3.6L (2004)
23. Remove special tools (holding-down devices 9611 and 9634) and carefully lift the entire unit, consisting of camshafts with chain and tensioning
element, out of the cylinder head. The chain must not jump over during this operation; reallocate if necessary. The groove or tab of the camshaft
position sensor cover must face upward.
24. Pull out valve tappets by hand.
Note;
-
Do not use a magnet.
25. Detach guide for valve tappet. Undo the pan-head screws (15 ea.) from the outside to the inside, and remove the guide.
Installing Valve Tappets of the Cylinder Bank 1 - 3 - Engine Installed
Installing valve tappets of the cylinder bank 1 - 3 - Engine installed
1. Check guide for damage. Refer to: Checking guide for valve tappet.
2. Fit guide. Tighten pan-head screws (M6 x 35) from the inside to the outside. Tightening torque 10 Nm (7.5 ft. lbs.)
3. Lightly oil the valve tappet and fit it in the guide.