Removing and Installing Hydraulic Valve for Valve Lift Adjustment - Engine Installed
1. Turn crankshaft clockwise until the bore 1 OT (top dead centre) in the belt pulley is aligned with the fixing bore on the crankcase. Position or fix
with fixing pin (short) of special tool 9595.
Note;
-
The basic camshaft setting can be checked only after removal of the camshaft closure caps.
2. Remove camshaft closure caps above the cylinder head oil extraction pumps. The closure cap of cylinder bank 1 - 3 is located on the flywheel side
and the closure cap of cylinder bank 4 - 6 is located on the pulley side. Drive awl into centre of the closure cap and lever off the cap.