911 Targa (996) F6-3.6L (2004)
Timing Plate: Service and Repair
Removing and Installing Hydraulic Valve For Camshaft Adjustment - Engine Installed
Removing and installing hydraulic valve for camshaft adjustment - engine installed
Caution: Risk of soiling! Absolute cleanliness is essential when working with hydraulic valves!
Removing hydraulic valve for camshaft adjustment
Note;
-
The rear muffler must be removed and the holder must be detached before the hydraulic valve on cylinder bank 4 - 6 can removed!
1. Remove the side shield on the respective side of the engine. Unscrew the two M6 hexagon-head bolts for this purpose.
Figure shows cylinder side 1-3
2. Remove cable plug of the hydraulic valve -1- by pressing the clip and pulling off the cable plug.
3. Unscrew both M6 pan-head screws (hexagon socket a/f 5) -Item 2 in the previous Figure- of the valve holder and remove the holder with the
screws -A-.
4. Remove retainer plate with integral seal -3- from the valve.