911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-261008.png)
4. For the following assembly procedure - piston installation, cylinders 1, 2 and 3 - the crankcase half and bearing housing unit must be held by at
least two screw connections. For this purpose, fasten two original cylinder head screws and plastic spacer sleeves, special tool 9613, from below.
Tightening torque 30 Nm (22 ft. lbs.). Use Torx screwdriver insert T50 or T55.
5. Turn crankcase by 180° on the assembly support. Cylinders 1, 2 and 3 face upwards.
6. Fit belt pulley. Screw in fastening screw by hand.
7. Turn crankshaft clockwise until the bore U4 on the belt pulley is aligned with the fixing bore on the crankcase. Position or fix with fixing pin
(short) of special tool 9595.
8. Remove preassembled connecting rod with piston of cylinder 1 from the assembly fixture.
9. Align the gaps of the upper piston rings offset by 180°. Make sure that the gap of the second piston ring is aligned with the twist lock.
