911 Targa (996) F6-3.6L (2004)
6. Tighten the 20 hexagon-head bolts in the specified tightening sequence with a torque wrench.
-
Tightening torque: 13 Nm (9.5 ftlb.)
7. Tighten the 2 or 4 hexagon~head bolts M6x20 of the oil extraction pump with a torque wrench.
-
Tightening torque: 13 Nm (9.5 ftlb.)
8. Position a new, dry, brown closure cap 45 mm on the bore of the exhaust camshaft on the belt pulley side and tap it gently into place with a plastic
hammer.
9. Insert 2 green closure caps into the small bores on the clutch side. Position the dry, new closure caps and tap gently into place with a plastic
hammer.
10. Fit 2 new covers for the magnetic hydraulic valves.
11. Fit the holders for the magnetic hydraulic valves. Position 4 hexagon socket head bolts M6x20 and tighten with a tightening torque of 10 Nm (7.5
ftlb.).
-
A: Holder for camshaft adjustment valve (NVS)
-
B: Holder for valve lift adjustment valve (VVS)
12. Fit ignition coils. Insert 3 ignition coils into the spark-plug recesses. Position 2 hexagon socket head bolts M6x25 per ignition coil and tighten with
a torque wrench.
-
Tightening torque: 10 Nm (1.5ftlb.)
13. Fit holder for the main muffler. Position 4 hexagon-head bolts: top 2 M8x30, bottom 2 M8x25, then tighten with a torque wrench with 23 Nm (17
ftlb.). Connect the electrical plug of ignition coil cyl. 5 and the 2 electrical plugs of the magnetic hydraulic valves. Clamp the cables of the
hydraulic valves in the sheetmetal brackets.
14. Install the shield. Insert the shield, position and tighten the 2 hexagon-head bolts M6x16.