911 Targa (996) F6-3.6L (2004)
2. Clip in wiring arrangement -A- and check for correct seating.
3. Connect and screw in (bayonet lock) the electrical plug connection for the gas discharge lamp -B- until it engages.
4. Engage the electrical plug connection (grey plug) on the control module.
5. Put the cap -1- into position and press down until both locking tabs -B- engage. Screw in both fastening screws -A-. Tightening torque: 4 Nm (3
ftlb.).
6. Fasten the control module in the correct position (observing the mounts on the closure cap) and fasten the holder with the fastening screws.
Tightening torque: 4 Nm (3 ftlb.).
7. Install main headlight and perform a function test.