911 Targa (996) F6-3.6L (2004)
-
Press out rear-wheel hub with pressure piece P 297A (tool A). Use the separator (tool B) for support. If there is not enough space for the wheel
hub between the press, appropriate shims will additionally be necessary.
-
Remove retainer plate (lid) (four screws).
-
Heat wheel bearing housing to approximately 100°C (maximum 120°C). Press out wheel bearing with tubular piece VW 415 A (tool C).
-
Press inner wheel bearing race off the wheel hub (Figure 426_97). To do this, use pressure piece P 297A (tool A) in combination with the
separator (tool B).