911 Targa (996) F6-3.6L (2004)
7. Combination wire, rear left:
-
Combination wire ABS and BVA in plug connection x 2/4 (white)
-
br/wt in pin 16 (ABS)
-
br/bl in pin 17 (ABS)
-
br/gr in pin 20 (BVA)
8. Combination wire, rear right:
-
br/wt in pin 18 (ABS)
-
br/bl in pin 19 (ABS)
9. The ground leads of the combination wires (brown) are the same on both right and left. Connection point No. 48 as shown in circuit diagram.
-
Strip 10 mm of insulation off the wires.
-
Push on shrink-fit hose.
-
Using a crimp connector, join brown wire of combination wire to brown wire of rear-end wiring harness
-
Shrink heat-shrinking tube with a hot-air gun so that wires are watertight.
10. BVA wire of combination wire (brown/green) at connection point No. 47 as shown in circuit diagram.
-
Strip 10 mm of wire.
-
Push on shrink-fit hose.
-
Using a crimp connector, join brown/green wire of combination wire to brown/green wire of rear-end wiring harness.
-
Shrink heat-shrinking tube with a hot-air gun so that wires are watertight.
11. The BVA wires of the combination wires (brown/black) are the same on both right and left. Connection point No. 46 as shown in circuit diagram.
-
Strip 10 mm of wire.
-
Push on shrink-fit hose.
-
Using a crimp connector, join brown/black wire of combination wire to brown/black wire of rear-end wiring harness.
-
Shrink heat-shrinking tube with a hot-air gun so that wires are watertight.
12. Wind commercially available PVC tape around wires.