911 Targa (996) F6-3.6L (2004)
Seat Heater Control Module: Service and Repair
Removing And Installing Control Module For Seat Heating
Removing and installing control module for seat heating
The control module for the seat is located on the right side for the driver's seat and on the left side for the passenger's seat.
-
-A- Backrest plug connection.
-
-B- Seat cushion plug connection.
-
-C- Plug connection for seat heating control module
-
-D- Expanding rivet.
1. Removing control module for seat heating
1.1. Refer to Removing and installing front seat.
1.2. Press the pin into the expanding rivet -D- with a thin screwdriver for example and remove the holder together with the rivet and the control
module.
1.3. Pull control module off the plug -C-.
2. Installing control module for seat heating
2.1. Push control module onto the plug -C-.
2.2. Fix the control module and holder with the expanding rivet -D- and press the pin in the rivet.
Seat heating line route
-
-A- Plug connection for backrest heating element
-
-a- Press plug for backrest heating element together -arrow- and pull from the plug connection -A-.
-
-B- Plug connection for seat heating element
-
-b- Push plug for seat heating element onto -B- until the plug connection engages.
-
-C- Base for seat heating control module.