911 Targa (996) F6-3.6L (2004)
/f6-3.6l/Page-730004.png)
Measure from wheel contact surface to the locating bore in the rear-axle side section (between toe and camber eccentrics).
Wheel alignment
Notes
Only check or adjust wheel-alignment values when prescribed preconditions are met in Adjusting Values For Suspension Alignment - 911 Carrera.
If the vehicle is measured front and rear, check and adjust the rear axle first. See: Specifications
After adjustment, tighten the appropriate screwed connections with the prescribed tightening torque.
The steering angle sensor must be calibrated if the previous wheel alignment values (on rear and/or front axle) for vehicles with PSM were changed!
Caution! Malfunctions in the PSM control range if the steering angle sensor is not calibrated or is calibrated incorrectly.
^
Calibrate the steering angle sensor with the wheels in straight-ahead position.
Rear axle
Prepare vehicle for checking and/or adjustment of wheel alignment values. Place front heels on rotary table and rear wheels on rotary / sliding plates.
Compress vehicle at front and rear by approximately 25 mm 2-3 times and allow it to spring back freely.
Adjusting toe
After loosening the lock nut, turn eccentric A appropriately.
Adjusting camber
