911 Targa (996) F6-3.6L (2004)
Rear axle
Measure from wheel contact surface to the locating bore in the rear-axle side section (between toe and camber eccentrics).
The vehicle height on the front and rear axle is adjusted by turning the adjusting nut No. 2.
The lock nut No. 1 must first be loosened. Use a hook wrench or special tool 9647 (hook wrench insert) for this purpose.
Adjusting nut No. 2
-
turn to the right = vehicle higher
-
turn to the left = vehicle lower
After adjustment of the lock nut(s) (No. 1) on the front and rear axle, tighten with special tool 9647 in conjunction with a torque wrench.
Tightening torque No. 1 = 50 Nm (37 ft. lbs.).
Front axle