911 Targa (996) F6-3.6L (2004)
-
Heat wheel bearing housing to approximately 100°C (maximum 120°C). Insert new wheel bearing, and then press again slightly using pressure
piece 9247/4 (tool D) and tubular piece VW 415 A (tool C).
-
Fit brake disc cover and retainer plate (lid). Unless there is a water drain on both sides, fit the water drain (arrow) in the correct position - i.e.
facing downward. Use correct tightening torques. Brake disc cover = 10 Nm (7.5 ft. lbs.) Retainer plate = 37 Nm (27 ft. lbs.)y
-
Press in wheel hub. To do this, place the wheel hub on the wheel centering device and press it on the wheel bearing inner race using pressure piece
VW 415 A (tool C).