911 Targa (996) F6-3.6L (2004)
Seals and Gaskets: Service and Repair
Removing and Installing Sealing Ring For Selector Shaft
Removal
Removal
1. Remove hydraulic control unit.
2. Disengage selector lever cable at transmission selector lever.
3. Drive out roll pin (1) until the selector lever can be pulled off from the shaft.
4. Pierce sealing ring with small screwdriver and pull out.
Installation
Installation
1. Thinly coat outer circumference and sealing lip of sealing ring with Vaseline.
2. Drive in sealing ring with special tool 3385 as far as the mounting face.