911 Targa (996) F6-3.6L (2004)
Differential Mount: Service and Repair
Removing and installing support for final drive
A Support for final drive
B Fastening screws
Removal
1. Remove final drive.
2. Unscrew fastening screws and remove support.
Installation
1. Fit support in the correct position (angled side facing upwards).
Note!
^
At the beginning of the series, supports with tabs were installed. These supports must be fitted with the tabs facing downwards.
A Tabs
2. Tighten fastening screws in two stages.
1st stage: Screw both screws to 5 Nm (3.7 ft. lbs.).
2nd stage: Tighten both screws to 65 Nm (48 ft. lbs.).
3. Install final drive.