911 Targa (996) F6-3.6L (2004)
Axle Shaft Assembly: Removal and Replacement
Removal
Removal
^
Before raising the vehicle, undo the drive shaft fastening at the wheel side! Actuate the brake while doing this!
^
Remove diagonal brace to facilitate assembly (2 M12 screws)!
1. Remove front wheel and underside panel.
2. Undo the pan-head screws of the drive shaft on the transmission flange.
Note!
^
The CV joint can come apart if the dust bellows holder -arrow- is removed or damaged. The joint must therefore be secured against falling
apart during removal, installation and transport with 8 mm screws + nuts (2 ea.)!
3. Disengage air guide on control arm.
4. Loosen stabilizer mount at stabilizer (counter with open-ended wrench).