911 Targa (996) F6-3.6L (2004)
Differential: Service and Repair
Removing and Installing Long Flanged Shaft
Removal
Removal
1. Remove right rear wheel.
2. Drain rear-axle oil.
Note!
^
Suction removal of the oil prevents rear-axle oil entering the ATF.
^
This would cause malfunctions of the hydraulic transmission control system.
3. Uncouple right drive shaft on the transmission side.
4. Unscrew three fastening screws for the mounting saddle.
5. Carefully pull out flanged shaft.
Installation
Installation
1. Replace square sealing ring in mounting saddle.