911 Targa (996) F6-3.6L (2004)
A New snap ring
Note!
^
Do not damage the drive shaft teeth when replacing them.
4. Grease the snap ring thoroughly and drive in the halfshaft flange -arrow-.
5. Check oil in front final drive.
6. Mount front drive shaft.
Removal
Removal
1. Drain transmission oil.
2. Remove drive shaft at the transmission and protect the shaft against damage (use scrap pieces of hose with a diameter of 30 mm).
3. Remove halfshaft flange.
4. Unclip hydraulic line for clutch slave cylinder.
5. Unscrew hexagon-head bolts for cover and press off cover on alternate sides.
Installation
Installation
Tightening torques:
Cover for final drive to transmission (M8) = 25 Nm (18 ft. lbs.)
Drive shaft to transmission flange (M10) = 81 (60 ft. lbs.)
Oil filler and oil drain plugs (M22) = 30 Nm (22 ft. lbs.)