911 Targa (996) F6-3.6L (2004)
Disassembly and Assembly Instructions
Disassembly and assembly instructions
Disassembly
1. Clamp the differential lock into the vice using special tool 9646 and unscrew the crown wheel screws.
2. Mark installation position of lid in relation to housing for retrofitting.
3. Unscrew countersunk screws (no. 7), remove lid and take out all inner parts. Mark thrust rings for refitting.
Assembly
Note!
^
Always replace the complete disc pack in the case of repairs.
Replacing individual discs is not permitted.
1. Lightly oil all surfaces of the discs, thrust rings and axles with transmission oil.
2. Install cup springs so that the cambers point inwards to the disc pack.
A Cup spring
B Outer disc
C Inner disc
D Thrust plate