porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

ABOUT US
Removing and Installing Sealing Ring For Input Shaft|Page 2817 > < Removing and Installing Sealing Ring For Input Shaft|Page 2815

911 Targa (996) F6-3.6L (2004)

Page 4
background image

3. Drive in sealing ring with special tool 9628 as far as the mounting face.
4. Install guide tube for release bearing. Always renew fastening screws and tighten with 24 Nm (18 ft. lbs.)
5. Fit release lever with release bearing.
6. Clean teeth of the input shaft and grease with a thin coat of Olista Longtime 3 EP (available as spare part).

Removing and Installing Sealing Ring For Input Shaft|Page 2817 > < Removing and Installing Sealing Ring For Input Shaft|Page 2815