911 Targa 4S (997) F6-3.8L (2007)
ATTENTION:
The optical waveguide can become damaged due to incorrect installation or if the requirements for handling optical waveguides are not
followed.
--> Observe the requirements for working with optical waveguides --> Workshop Manual '9772IN Optical waveguide - MOST bus'.
6. Route optical waveguide.
6.1 Only for vehicles with Tire Pressure Monitoring (TPM) control unit:
Unscrew fastening nuts on TPM control unit and lay control unit aside. --> Workshop Manual '443419 Removing and installing Tire Pressure
Monitoring control unit'
6.2 Remove connection point holder.
6.2.1 Only for vehicles with optical waveguide components (CD autochanger and/or amplifier) in front luggage compartment; Disconnect
optical waveguide connection point --> Figure 11-B-.
6.2.2 Remove connection point holder --> Figure 11-A- from plenum panel using pointed-nose pliers.
6.3 Only for vehicles without optical waveguide components in the front luggage compartment:
Pull protection cap --> Figure 12-A- off the optical waveguide.
NOTE:
Given the vehicle variants and the wide range of equipment options using optical waveguide components, only two possible methods of routing the
optical waveguide are described here.