911 Targa 4S (997) F6-3.8L (2007)
4. Attach the connector -3- to the motor for seat adjustment -1- (-arrow A-) until it engages firmly.
5. Push motor for seat adjustment -1- under the support -2- (-arrow B-).
INFORMATION: When installing the motor for seat adjustment, make sure the two seat rails are in the same position.
6. Push motor for seat adjustment -1- onto the short drive shaft by twisting slightly -arrow C-.
7. Press motor for seat adjustment -1- into the support -2- at the boot -arrow D-.
8. Clip in sleeve of long drive shaft -2- of seat adjustment motor -1- on the support.
Subsequent work
Install front seat. Refer to Removing and installing front seat.