911 Targa 4S (997) F6-3.8L (2007)
3. Unscrew the fastening nuts for both holders line, open the holder and take out the line.
INFORMATION:]
-
When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
4. Unscrew the fastening screws -1- of the line condenser-condenser and pull the line out of both condensers.
Installing the condenser-condenser line
INFORMATION:
-
When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.
-
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if necessary.
-
Wet the O-rings of the refrigerant lines with refrigerant oil.
-
Do not open the plugs for the lines and connections until shortly before installation.
-
Close off all lines and connections using suitable plugs during removal.
1. Carefully push the lines into the condensers and screw tight with the fastening screws.
-
Tightening torque: 14 Nm (10.5 ftlb.)