911 Targa 4S (997) F6-3.8L (2007)
Insert wheel bearing at the correct position, then press again on the wheel bearing housing with only slight force using a suitable pressure piece
(9247/4), see pressure piece (4 x) P 9247 and tubular piece VW 415 A.
Warning:
Hot wheel bearing housing!
^
Danger of burns
-
Wear heat-resistant gloves!
2. Fit lid for the wheel bearing on the wheel bearing housing (4 M8 screws). - Tightening torque: 37 Nm (27 ftlb.).
3. Press in wheel hub.
Pressing in wheel hub
Position wheel bearing housing on wheel hub and press on wheel bearing inner race using a tubular piece VW 415 A.
4. Fit brake cover plate on wheel carrier.
Screw in and tighten screws on brake cover plate.
-
Tightening torque: 10 Nm (7.5 ftlb.)
Subsequent work
-
Install front wheel bearing housing (wheel carrier).