911 Targa 4S (997) F6-3.8L (2007)
/f6-3.8l/Page-664029.png)
-
Disposal regulations for airbag units must be observed. Refer to Disposal of airbag and seat-belt pretensioner units
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Remove ignition key. Disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier (e.g. body, seat frame)
is avoided. Refer to Work instructions after disconnecting the battery.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
Removing head airbag unit
WARNING: Removing and installing airbag unit.
-
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units. Refer to Safety regulations for handling airbag and seat-belt
pretensioner units
-
Disposal regulations for airbag units must be observed. Refer to Disposal of airbag and seat-belt pretensioner units
-
If removed for an extended period, the airbag unit must be stored in a safe place.
-
Remove ignition key. Disconnect the battery. Route or insulate the ground strap so that all contact with a ground carrier (e.g. body,
seat frame) is avoided. Refer to Work instructions after disconnecting the battery.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. With a screwdriver, carefully release the locking element of the plug connection for the airbag unit and remove the plug from the airbag module.
2. Unscrew the three fastening nuts -1- and remove the ground lead -2-.
