911 Targa 4S (997) F6-3.8L (2007)
Steering Wheel: Service and Repair
Removing and Installing Steering Wheel
Removing and installing steering wheel
Warning notes for removing and installing steering wheel
Warning:
Danger of injury and damage to property as a result of incorrect handling of airbag units! Always observe the safety regulations for handling
airbag units.
^
In the case of incorrect handling, system faults may occur resulting in the triggering of the airbag or failure to do so.
-
The airbag unit must always be placed so that the airbag opening faces upwards.
-
If removed for an extended period, the airbag unit must be kept in a locked place.
-
Switch off ignition and leave ignition key inserted (steering must not be locked). Disconnect the battery. Route or isolate ground strap so that all
contact with a ground carrier (e.g. body, seat frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag connectors.
Removal
1. Disconnect battery.
2. Remove steering wheel airbag unit.
Releasing driver's airbag unit
3. Turn wheels to straight-ahead position. Before removing steering wheel, put a mark (e.g. color marking) on steering wheel and steering column
(centering of airbag spiral spring).
4. Remove steering wheel by releasing multiple-tooth screw.
Installation
Information:
^
The steering wheel is made of magnesium alloy. The tightening torques must be strictly observed.
^
Wheels straight ahead and observe the previously-applied marking.
^
Replace multiple-tooth screw after each removal (micro-encapsulated thread).
^
Observe tightening torque. - Tightening torque: 50 Nm (37 ftlb.)
^
Airbag unit must lock with an audible click! Check by pulling at airbag unit.