911 Targa 4S (997) F6-3.8L (2007)
Control Arm: Service and Repair
Removing and Installing Diagonal Arm
Removing and installing diagonal arm
Removing diagonal arm
1. Raise the vehicle.
2. Loosen diagonal arm (described below) and remove it.
Loosen threaded joint -1- connecting diagonal arm to trailing arm (wishbone). Turn in wheel as required.
Loosen threaded joint -2- connecting diagonal arm to body through the opening (bore) in the underbody panel.
On the 911 Turbo, remove the spoiler -3- at the diagonal arm (air guide for the brake cooling system). Generally, the spoiler -3- must be removed
in order to replace the diagonal arm.
Diagonal arm
Installing diagonal arm
-
Installation is carried out in reverse order.
Use new lock nut(s).
Tighten threaded joints -1 + 2- to the specified tightening torque.
Diagonal arm