911 Targa 4S (997) F6-3.8L (2007)
/f6-3.8l/Page-384001.png)
Wiring Harness: Service and Repair
Replacing connectors for transmission wire harness
Preliminary work
1. Remove ATF pan.
2. Remove electrohydraulic control unit.
Replacing connectors for transmission wire harness
Information:
Note the arrangement of the cables for the connector housings to be replaced and do not get the cables mixed up.
1. Hold the connector housing with the connector tab -1- up and press the release tool press-out tool set Nr.155 Pos.1, tool no. 93005 (Mibostahl set)
into the openings above and below the contact -arrow- until the resistance of the locking lug on the contact is clearly overcome. Leave the tool in
the connector housing.
Releasing connector at the front
2. Position the release tool press-out tool set Nr.155 Pos.1, tool no. 95511 (Mibostahl set) at the upper connector tab -1- and break this off in an
upward direction using the tool. -arrow-
