911 Targa 4S (997) F6-3.8L (2007)
Removing clutch
Information:
When loosening the clutch pressure plate, ensure that the stop on the adjustment mechanism -arrow- is detached from the housing. The stop must dip
loosely into the housing as far as the block. Press the stop towards the flywheel, if necessary.
Stop on adjustment mechanism
1. Fit toothed segment 9538/1 -1-.
Loosening threaded joint
Information:
To avoid deforming the clutch pressure plate, always loosen fastening screws in at least five steps and in diagonally opposite sequence.
2. Loosen the pressure plate.
3. Remove pressure plate and drive plate.
Installing clutch
Information:
^
Clean the friction surfaces of the flywheel and pressure plate prior to installation, e.g. with brake cleaner.
^
Surfaces of friction linings must be free from contamination, especially oil and grease.
1. Centering mandrel 9102 with the drive plate must be inserted into the guide joint (needle sleeve).
2. Fit toothed segment 9538/1 -1-.
Tightening threaded joint
Information:
To avoid deforming the clutch pressure plate, tighten fastening screws in at least 5 steps and in diametrically opposite sequence.
Always replace fastening screws.
3. Fit pressure plate.