911 Targa 4S (997) F6-3.8L (2007)
Drive/Propeller Shaft: Service and Repair
Removing and installing cardan shaft
Preliminary work
Danger:
Vehicle raised incorrectly.
^
Danger of fatal injury or material damage should the vehicle fall down.
-
Raise the vehicle at the prescribed jacking points.
1. Jack and raise the vehicle at the prescribed jacking points.
2. Remove underbody panelling.
Removing cardan shaft
Information:
^
Observe max. joint angle of 20° during removal and fitting. Furthermore, the cardan joint must not be loaded at max. deflection (stop).
1. Remove transmission bracket.
1.1.
Support transmission -1- with a transmission jack -2-.