911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
Spoilers, Flaps, and Air Dams: Technical Service Bulletins
Spoilers - Approved Installation of Aero Kits
Group
6
Number
9610
Model
6 Cyl.
Part Identifier
6603
October 3, 1996
Subject:
Aero Kits
ATTENTION: Service Manager / Service Technician
Models Affected:
911 Carrera Model Year 1995 - on
911 Turbo Model Year 1996 - on
Concern:
Porsche approved Aero Kits for the above-mentioned vehicles.
General Information:
Porsche has approved the installation of 3 Aero Kits for use on the above-mentioned vehicles. The Aero Kits were tested as complete kits, therefore,
installation of only the front or only the rear spoiler must not be done.
When installing the Aero Kits on a vehicle with a normally aspirated engine, an additional hot air connecting piece and gasket must also be installed (see
additional parts listed below).
On vehicles with a retractable rear spoiler the following steps must be done to disable the spoiler warning system:
-
Remove fuse # 37 from the CEB.
-
Remove the spoiler warning bulb in the clock.
-
Remove the spoiler switch from the center console and install a blank switch cover.
-
Secure and insulate all disconnected wiring.
Vehicle Application:
Aero Kit Part Number
Vehicle Application
000 044 800 29
911 Carrera without roof mount
brake light
000 044 800 28
911 Carrera with roof mount brake
light
000 044 800 16
911 Turbo and 911 Carrera 4S
Additional parts for normally aspirated engines equipped with fresh air/engine switchover flap.
Part Number
Description
993 211 085 02
Hot air connecting piece
993 211 270 40
Gasket