911 Turbo AWD F6-3600cc 3.6L SOHC Twin Turbo (1997)
NOTE:
^
Never apply grease to the brake pad backplates (back brake pads). To prevent the brake pads from corroding in the caliper, however, the
seating and guide surfaces are protected by a thin grease coat.
^
Use Optimoly HT (Cu paste) or Plastilube (supplied by Schillings, Postfach 1703, D-73431 Aalen) for this purpose.
^
Lubricate attachment eyes of the cross spring with Optimoly TA or Plastilube. If necessary, install new cross spring in such a manner that the
flat side points towards the brake disc. Make sure the cross spring (arrow) engages correctly. Do not use force to push the spring into its seat
(risk of damaging the holder).
^
Engage warning contact lever and warning contact. If necessary, disengage the cross spring again for this purpose.
^
With the vehicle stationary, operate brake pedal firmly several times to move the brake pads into the position corresponding to their operating
position.
^
Then check brake fluid level and top up if required.
